Panasonic CF-73 Series Reference Manual page 89

List of Error Codes
Error Code/Message
*1
0613: Serial Port configuration
changed
*1
0614: Serial Port 1 config. error
- device disabled
*1
The port name, such as A or B,
is displayed, indicating the
conflicting ports.
Press <F1> to resume, <F2> to
Setup
Operating System not found
Action
I/O address and IRQ settings are in conflict.
Run the Setup Utility and change the settings in
[Advanced] menu so there are no port conflicts.
Write down the error details and press to run the
Setup Utility. Confirm the settings, and change the
settings to the appropriate values as needed.
( page 76)
The OS is not properly installed on the floppy disk or the
hard disk that you are trying to boot from.
If the computer cannot be booted from the floppy
disk drive connected to the USB port, make sure
there are no non-bootable floppy disks in the floppy
disk drive, then run the Setup Utility and set [Legacy
USB Support] in [Security] menu to [Enable].
If the computer cannot be booted from the hard disk,
confirm whether the hard disk is properly recognized
in [Information] menu of the Setup Utility. (
78)
If the hard disk is recognized, perform the
reinstallation procedure. If not, contact Panasonic
Technical Support.
89
page