External Display - Panasonic Toughbook CF-28 Series Reference Manual

External Display

External Display Port
1
Power off your computer
Do not shut down using the standby or hibernation function.
2
Connect the external display to your computer
NOTE
For more detailed information, refer to the operation manual of the external
display.
3
Turn on the external display, then turn on your computer
Windows 98
When [Add New Hardware Wizard] is displayed, follow the on-screen instructions.
After Windows star ts up, the screen is displayed on the display destination set in
[Start] - [Settings] - [Control Panel] - [Intel
screen is not displayed based on the [Display] setting in the Setup Utility.
It is possible to change the setting to display only on the external display or on both
the internal LCD and the external display with Fn + F3 .
This combination does not work in the following cases:
When the [MS-DOS Prompt]* screen is set to "Full Screen".
Windows 98 When the computer is in the Dual-Display mode.
* Windows 2000 Windows NT
CAUTION
Do not switch displays repeatedly using the Fn + F3 combination while
MPEG files are playing.
NOTE
Windows 98
When the [MS-DOS Prompt] screen is set to "Full Screen" in simultaneous
display, the screen will only be shown on one of the two displays. To use MS-
DOS mode in Full Screen with simultaneous display, reboot the computer and
press Ctrl at start-up to operate the computer in the Command prompt only.
4
Windows 98 Windows 2000
Select your external display
Set your external display for [Monitor] in [Start] - [Settings] - [Control Panel] - [Dis-
play] - [Settings] - [Advanced].
When a monitor that does not conform to the Plug & Play standards is connected,
select [Change]* and make the monitor settings.
* Windows 2000 : [Monitor] - [Properties] - [Driver] - [Update Driver]
NOTE
For more detailed information, refer to the operation manual of the external display.
®
About [Intel Graphics Technology]
The selection of the display destination, adjustment of the brightness and contrast, and
setting of the hotkey to change the display destination can be done in [Start] - [Settings]
- [Control Panel] - [Intel ® Graphics Technology].
( "Starting Up/Shutting Down")
®
Graphics Technology] - [Devices]. The
: [Command Prompt]
44