Normal Sounds - Hisense AP-10CR1SEPS Use And Installation Instructions

Clock function
1. You can or adjust the real time by pressing CLOCK button.
set
CLOCK
2. Use the Up and Down buttons to set the correct time.
3. Press CLOCK button again once the real time is set.
TIMER ON/OFF
It is convenient to set the timer with TIMER ON/OFF buttons.
The CLOCK must be set before using the TIMER function.
NOTE:
Using the TIMER
The TIMER ON button can be used to turn on the unit
automatically at the time you set.
1. Press TIMER ON, Then "On 12:00" flashes on the LCD.
TIMER ON
2.Press the UP or DOWN button to get your desired time of day
to turn on the appliance.
Increase
Decrease
Press the UP or DOWN button once to increase or
■
decrease the time setting by 1minute.
Press and hold the UP or DOWN button for 2 seconds to
■
increase or decrease the time setting by 10 minutes.
Press and hold the UP or DOWN button for a longer time
■
to increase or decrease the time setting by 1 hour.
ON
15
3.When the desired time is displayed on the LCD, press the
TIMER ON button to confirm it.
A "Beep" will be heard, and "ON" stops flashing.
The TIMER indicator on the appliance lights up.
4.After your desired time is displayed for 5 seconds, the clock
will display on the remote control display instead of the
t .
desired ime
To cancel Timer On
Press TIMER ON button again, when a "beep" can be heard and the
indicator disappears, the TIMER ON mode has been canceled.
It is similar to set TIMER OFF, you can make
NOTE:
the appliance unit switch off automatically at the time you set.
TIMER OFF
SWING
Press SWING once to change vertical airflow direction. Press
again to hold the airflow louver at desired direction.
NOTE:
Airflow is automatically adjusted to a certain angle in accordance
■
with the operation mode after turning on the unit.
The direction of airflow can be also adjusted to your own
■
requirement by pressing the SWING button.
Do not turn the vertical adjustment louvers manually, to
■
prevent damage. Turn off the unit first and cut off the
power supply, then restore power again to reset the louver.

Normal Sounds

When your air conditioner is operating normally, you may hear
sounds such as:
Air movement from the fan.
■
Clicks from the thermostat cycling.
■
Vibrations or noise due to poor wall or window construction.
■
A high-pitched hum or pulsating noise caused by the
■
high-efficiency compressor cycling on and off.
SWING