Portable Air Conditioner Use; Starting Your Portable Air Conditioner - Hisense AP-10CR1SEPS Use And Installation Instructions

Operating your portable air conditioner properly helps you to
obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■
The air conditioner display shows the current room
temperature.
■ When changing modes while the air conditioner is in
operation, the compressor will stop for 3 to 5 minutes before
restarting.
NOTE:The symbols may be different from these models, but the functions are similar.
1. Select the mode. See " MODE ".
2. Select the fan speed. See " FAN ".
3. Set the temperature. See "TEMPERATURE".
4. Press POWER button to start the air conditioner.
NOTE:
Keep upright at least 2 hours before use to prevent
damaging the compressor.
When the air conditioner is turned on for the first time after it is
plugged in, it will run in the Smart Mode. When the air conditioner
is turned on at all other times, it will run according to the previous
setting. Smart Mode can be selected with the remote control only.
Only if the unit is operated in EXTREMELY HUMID air, water
will be collected in the container inside the unit. If the water
container is full, the air conditioner will stop. The screen will
displays "E5" to inform you to empty the internal container.
1.Press and release MODE until you see the symbol flashes for the
operating modes:
2. Choose Cooling, Dry, Fan Only or Heating.
Cooling-Cools the room. Press FAN to select High,
Mid or Low. Press the Plus or Minus button to adjust the
temperature.

PORTABLE AIR CONDITIONER USE

Starting Your Portable Air Conditioner

MODE
If a button is pressed during this time, the compressor will
not restart for another 3 to 5 minutes.
■
In Cooling or Dry mode, the compressor and condenser fan
will stop when the room temperature reaches the set
temperature.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Dry-Dries the room. The air conditioner automatically selects
the temperature. The fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room
Fan Only mode. Press FAN to select High, Mid or Low.
Heating-heats the room. Press FAN to select High,Mid or
Low. Press the PLUS or MINUS button to adjust the
temperature.
NOTE: Heating is NOT available for cooling.To cool,that
mode must be selected.
Fan Speed
1.Press and release FAN to choose the desired fan speed.
2.Choose High, Mid or Low.
Auto-automatically controls the fan speed depending on the
current room temperature and temperature control setting.
High-for maximum fan speed
Mid-for normal fan speed
Low-for minimum fan speed
10
(Optional)
FAN
.