Hisense AP-10CR1SEPS Use And Installation Instructions page 15

Temperature
Press the UP button to raise the temperature. Press
■
the UP button once to increase the set temperature
by 1 °F (1 °C ) .
UP
Press the DOWN button to lower the temperature.
■
Press the DOWN button once to decrease the set
temperature by 1°F(1°C)
NOTES:
In the Cooling and Heating mode, the temperature can be
■
set between 61°F and 86°F(16°C and 30°C).
In Fan Only mode,the temperature cannot be set.
■
Sleep mode
SLEEP mode can be set in Cooling, Heating or Dry operation
mode. This function gives you a more comfortable environment
for sleep.
NOTE:
The appliance will stop operation automatically after operating
■
for 8 hours.
Fan speed is automatically set at low speed.
■
In the Cooling mode, if the current room temperature is
■
below 79°F (26°C) , the temperature will automatically increase
1°F(1°C) during the first hour after Sleep control is
activated,then remain the same.
If room temperature is 79°F(
not change.
In Heating mode, the set temperature will decrease by 6
■
at most,during 3 hours, then keeps steady.
1. Press MODE to select Cooling, Heating or Dry.
NOTE: Sleep control cannot be selected when Fan Only
or SMART is selected.
2. Press the UP or DOWN button to set the temperature.
3. Press SLEEP. After 5 seconds, the lights on the control panel
display will dim.
.
DOWN
SLEEP
26 °C ) or above, set temperature will
The temperature and airflow direction may be adjusted
NOTE:
during Sleep control. The fan speed is automatically set to
Low speed. After 5 seconds, the lights on the control
panel display will dim again.
4.To turn off Sleep control, press SLEEP, MODE, ON/OFF,FAN,
SUPER or wait 8 hours for Sleep control to turn off automatically.
The air conditioner will return to previous settings after
NOTE:
Sleep control is turned off.
I FEEL
The temperature sensor built into the remote controller is activated.
It can sense its surrounding temperature, and transmit the signal
back to the unit,when the remote control is pointed towards the air
conditioner. The unit can adjust the temperature so as to provide
maximum comfort.
NOTE:
The I FEEL function is active, as a default setting from the factory.
■
To de-activate the I FEEL function, press the I FEEL button for
■
about 5 seconds, and the transmit signal in the display will
disappear, the I FEEL function will be de-activated.
Pressing the I FEEL button once will activate I FEEL function
■
again.
DIMMER
Press the DIMMER button to turn off the light and the control
panel display.
°F (3°C)
NOTE:
When in DIMMER mode, new control inputs will return lighting
■
and display to normal.
14
IFEEL
DIMMER