Using The Remote Control - Hisense AP-10CR1SEPS Use And Installation Instructions

Temperature
Press the PLUS button to raise the temperature. Press the
PLUS button once to increase the set temperature by
PLUS
Press the MINUS button to lower the temperature. Press the MINUS
button once to decrease the set temperature by
MINUS
NOTE:
In the Cooling mode, the temperature can be set between
61°F and 86°F (16°C and 30°C)
In Fan Only mode, the temperature cannot be set.
Insert the Batteries
1. Remove the battery cover along the arrowed direction.
2. Insert new batteries making sure that the (+) and (-) of
battery are matched correctly.
3. Re-attach the cover by sliding it back into position.
NOTE:
Use the included 2 standard AAA(1.5volt) batteries. Do not use
■
rechargeable batteries. Replace batteries with new ones of the same
type when the display becomes dim, or after 6 months.
If you reload batteries after removing the old ones, previous settings will
■
be lost.
Do not recharge non-rechargeable batteries.
■
Do not mix different types of batteries such as alkaline, carbon-zinc, or
■
rechargeable batteries.
Do not mix old and new batteries.
■
Batteries are to be inserted with the correct polarity.
■
Exhausted batteries are to be removed from the product.
■
Storage tip
The clip on the back of the unit can be used to store the remote
control.
1°F (1°C).
1°F (1°C).
.

Using the Remote Control

To change the temperature display between
press both the Plus and Minus Adjust buttons at the same time.
ION (Optional)
Press the ION button to start or stop the Plasma Generator.
When the ION indicator light of the appliance flashes,
Plasma Generator will turn on.
Holder
How to Use
To operate the room air conditioner, aim
the remote controller to the signal receptor.
The remote control will operate the air
conditioner at a distance of up to 23' (7m) when
pointing at signal receptor of the air conditioner.
Signal receptor
■
11
°C a °F
nd
the