Hisense AP-10CR1SEPS Use And Installation Instructions page 14
Hide thumbs
Also See for AP-10CR1SEPS:
- Use and installation intructions (46 pages) ,
- Use and installation instructions (10 pages)
Table of Contents
Advertisement
Available languages
Available languages
Dry-Dries the room. The air conditioner automatically
■
selects the temperature. The fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
A decrease or rise of up to
remote controller if you still feel uncomfortable.
Fan Only-Only the fan runs. Press FAN button to adjust
■
fan speed.
NOTE: Auto fan speed cannot be selected in Fan Only mode.
Heating-Heats the room. Press FAN to select the fan speed.
■
Press the up or down TEMP button to adjust the temperature.
SMART Mode
Press the SMART button,regardless If the unit is on or off, to set
temperature and fan speed automatically based on the actual
room temperature.
SMART
Operation mode and temperature are determined by indoor temperature.
With Heater models
70°F 21°C
(
)
70-73°F
(
21-23°C
)
73-79°F
(
23-26°C
)
79°F 26°C
(
)
Cooling only models
23°C 73°F
(
) or below
23-26°C 73-79°F
(
)
26°C 79°F
(
)
NOTE:
Temperature, airflow and direction are controlled
automatically in smart mode. However, a decrease or rise of
up to
4°F 2°C
(
)
can be set with the remote controller
if you still feel uncomfortable.
Button
FAN
SWING
4°F (2°C)
can be set with the
72°F 22°C
(
Room temperature decrease
4
°F(
2
°C
)
after operate for
3 minutes
79°F 26°C
(
Room temperature decrease
4
°F(
2
°C
)
after operate for 3
minutes
26°C 79°F
(
Adjustment
Indoor fan speed alternates among
High, Medium and Low each time
this button is pressed.
SUPER
SUPER button is used to start or stop fast cooling or heating.
1. Press SUPER button. The air conditioner automatically
sets the fan speed to High and the temperature to 61°F 16°C
Fast heating operates at auto fan speed,changing the set
temperature automatically to 86 ° F 30°C
2. To turn off Super control, press any button on the remote
control or control panel except Timer On, Timer Off, Clock,
Dimmer,Ifeel and Swing.
NOTE:
In the SUPER mode you can set airflow direction or timer.
■
SMART mode is not available in SUPER mode.
■
SUPER button is ineffective in SMART mode.
■
Fan Speed
1. Press FAN button, Choose desired fan speed.
)
Auto-Automatically controls fan speed depending on
■
current room temperature and temperature control
)
setting.
Auto fan speed cannot be selected in Fan Only
NOTE:
mode.
High for maximum fan speed
■
)
Mid for normal fan speed
■
Low for minimum fan speed
■
13
(
) .
SUPER
fast heating
fast cooling
ON
ON
OFF
OFF
(
).
Hide quick links:
Advertisement
Table of Contents
