TP-Link EAP115 User Manual page 30

tags to the clients which connect to the corresponding wireless network. It supports maximum
8 VLANs per radio. The clients in different VLAN cannot directly communicate with each other.
Clients connected to the device via cable do not belong to any VLAN. Thus wired client can
communicate with all the wireless clients despite the VLAN settings.
Click in the Modify column, the following content will be shown.
Click to add up to 8 wireless networks per radio.
Enter up to 32 characters as the SSID name.
SSID Name:
Wireless VLAN Set a VLAN ID (ranges from 0 to 4094) for the wireless network. VLAN 0 means
VLAN function is disabled. Wireless networks with the same VLAN ID are grouped
ID:
to a VLAN.
Enable this function, AP will broadcast its SSID to hosts in the surrounding
SSID
Broadcast: environment, as thus hosts can find the wireless network identified by this SSID. If
SSID Broadcast is not enabled, hosts must enter the AP's SSID manually to connect
to this AP.
Security Mode: Select the security mode of the wireless network. For the safety of wireless
network, you are suggested to encrypt your wireless network. This device
provides three security modes: WPA-Enterprise, WPA-PSK (WPA Pre-Shared Key)
and WEP (Wired Equivalent Privacy). WPA-PSK is recommended. Settings vary in
different security modes as the details are in the following introduction. Select
None and the hosts can access the wireless network without password.
Portal provides authentication service for the clients who want to access the
Portal:
wireless local area network. For more information, refer to
is enabled, the configurations in
SSID Isolation: After enabling SSID Isolation, the devices connected in the same SSID cannot
communicate with each other.
Figure 6-13 SSIDs
6.4.2 Portal
22
6.4.2 Portal. After Portal
will be applied.