Juniper MX960 Quick Start Manual page 24

MX960 3D Universal Edge Router Quick Start
Table 3: MX960 High-Capacity DC Power Supply LEDs
Connected Inputs
INP0 connected, INP1 disconnected
INP0 disconnected, INP1 connected
INP0 connected, INP1 connected
INP0 connected, INP1 disconnected
INP0 disconnected, INP1 connected
INP0 connected, INP1 connected
24
Replace the clear plastic cover over the terminal studs on the faceplate.
13.
Switch on the dedicated customer site circuit breaker.
14.
Verify that the
INPUT 0 OK
15.
steadily. If using two feeds, verify that both
power supply are lit steadily. The
in reverse polarity. Check the polarity of the power cables to fix the condition (see
Figure 12 on page 25 and
Move the switch to the on (
16.
Verify that the LED is lit green steadily. See
DC OK
17.
on MX960 high-capacity DC LEDs.
LEDs
DIP
Switch
Position
INP-0 OK
0 (1 Green
input)
Off
Green
1 (2 Green
inputs)
Off
Green
Repeat steps 1-17 for installing power supplies in slots 1, 2, and 3, where required.
18.
or LEDs on the power supply are lit green
INPUT 1 OK
INPUT 0 OK
will be lit amber if that input's voltage is
INPUT OK
Table 3 on page 24.
| ) position.
Table 3 on page 24
INP-1 OK
Off
Green
Green
Off
Green
Green
and INPUT 1 OK LEDs on the
for information
DC OK PS FAIL
Green Off
Green Off
Green Off
Off Red
Off Red
Green Off
Copyright © 2015, Juniper Networks, Inc.