Juniper MX960 Quick Start Manual page 18

3d universal edge router

Hide thumbs Also See for MX960:

Table of Contents

MX960 3D Universal Edge Router Quick Start

Figure 9: MX960 AC Power Input Mode Switch

CAUTION:

Do not use a pencil, because fragments can break off and cause

damage to the power supply.

Using both hands, slide the power supply straight into the chassis until the power

supply is fully seated in the chassis slot. The power supply faceplate will protrude

beyond the chassis.

The small tab on the metal housing that is controlled by the release lever must be

inside of the corresponding slot at the bottom of the power supply (see

Figure 9 on page

18). This tab is used to pull the power supply down in the chassis

slot, prior to removing the power supply.

While firmly pushing the handle on the power supply faceplate with one hand, use

your other hand to pull the spring-loaded locking pin in the release lever away from

the chassis and turn the release lever clockwise until it stops.

Let go of the locking pin in the release lever. Ensure that the pin is seated inside the

corresponding hole in the chassis.

Locate a power cord with the type of plug appropriate for your geographical location

(see AC Power Cord Specifications for the MX960 Router).

Plug the power cord into the corresponding appliance inlet located in the chassis

directly above the power supply. This is the recommend receptacle when using the

power supply in one-feed mode. If using the power supply in two-feed mode, plug the

second power cord into the receptacle on the power supply.

NOTE:

Each power supply must be connected to a dedicated AC power

feed and a dedicated customer site circuit breaker.

Table of Contents