Table Of Contents; Unpacking The Fireplace - Jøtul GI 535 DV IPI New Harbor Installation And Operation Instructions Manual

Table of Contents

1. Unpacking the Fireplace ......................... 3
2. Specifications .............................................4
3. General Information ................................. 5
4. Safety Information ..................................6
5. Installation ............................................ 7
5.1 Fireplace Requirements ...................... 8
5.2 Hearth and Clearance Protection .....8
5.3 Clearances ...............................................9
6. Vent Guidelines ................................. 10
6.1 Masonry Fireplaces ............................ 11
6.2 Factory-built Fireplaces ......................12
6.3 Vent Connection .................................13
7. Fireplace Assembly ..............................14
7.1 Gas Connection .................................... 14
7.2 Gas Pressure Test ................................ 14
7.3 Fuel Conversion ................................... 16
7.4 High Altitude Adjustment ............... 18
7.5 Final Positioning.................................. 19
7.6 Brick Panel Kits .................................... 19
7.7 Reflective Glass Panel Kit ................. 20
7.8 Log Set Installation .............................21
7.9 Backer Plate Installation ................... 23
7.10 Trimable Backer Plate Install ........... 23
7.11 Hidden Hanger Bracket ...................24
7.12 Front Cast Iron Overlay .....................24
8. Operation ............................................ 25
8.1 Initial System Check ........................... 25
8.2 Fireplace Operation .......................... 27
8.3 Remote Control Functions ...............28
9. Maintenance ...................................... 32
9.1 General and Annual Cleaning .......... 32
9.2 Accent Lamp Bulb Replacement .... 32
9.3 Battery Replacement ........................ 32
9.4 Glass Care and Replacement ........... 33
10. Illustrated Part Breakdowns ...............34
11. Appendix A ........................................ 39
11.1 Approved Vent Manufacturers ......39
11.2 Burner Re-installation ......................39
11.3 Proflame 2 Wiring Diagram .......... 40
11.4 Warranty Statement ........................ 41
12. Lighting Instructions .............................43
1.0 Unpacking the Fireplace Insert
1. Thoroughly inspect the appliance for shipping damage and
immediately contact the dealer if any is found.
2. A Miscellaneous Hardware Kit is packed within the firebox
crate with this manual. Confirm these contents:
• Fuel Conversion Kit, LP
• Fireplace Conversion Notice Plate
• Rock Wool Ember Fibers
• Remote Transmitter
• Transmitter Wall Bracket
• Four, 1.5 v AA IFC Back-up Batteries
• Three, 1.5 v AAA Remote Transmitter Batteries
• Safety Screen Barrier Guidelines
3. Detach the firebox from the pallet with removal of the
attachment bracket screws at each side of the firebox base.
4. Remove the Latch Tool from the shipping pallet. Use it to
disengage the two spring latches from the glass frame
as shown in fig. 1. Engage the tool prong with the Latch
receiver hole and pull the latch hook forward and up to
detach it from the glass frame slot. Pivot the top of the
frame forward to disengage it from the bottom corners of
the firebox. Set the glass frame out of the way.
5. The Log Set is inside the firebox. Remove and set it out of
the way until you are ready to install it.
6. PRE-INSTALLATION FIT UP: Leveling bolts are located at
each corner of the firebox base to allow a maximum
1/2" adjustment to correct hearth irregularities. Before
assembly, locate the firebox in its final position within the
fireplace and adjust the leveling bolts as necessary to level
and plumb the unit. Front bolts are accessible in each side
compartment through the fireplace front. Tip the firebox
forward to adjust the rear bolts out of the base.
Pull the unit back out of the fireplace and read the
installation requirements in this manual before proceeding
with assembly and installation.
7.
The remote control IFC and hand-held Transmitter have
been synchronized at the factory before the batteries are
removed for shipping. See Sect. 8.1, page 25, for complete
installation instructions.
Figure 1.1
Pull each Spring Latch OUT and UP to
disengage it from the Glass Frame. Swing
the glass frame down.
139775_R03 GI 535 DV IPI June 2016
3