Maintenance - Stamina BODYTRAC GLIDER 1060 Owner's Manual

OPERATIONAL INSTRUCTIONS
LOAD ADJUSTMENT
The resistance of the shock can be adjusted by twisting the adjustment
knob at the top of the shock. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION:
The shock gets
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can change to attach the PEDAL STRAP(35) to the
lower position in the PEDAL CAP(34) as shown in illustration 1 below. Run the PEDAL STRAP(35) through
the opening from the bottom of the PEDAL CAP(34). Pull the PEDAL STRAP(35) to make the Knot against
the bottom of the PEDAL CAP(34). Run the PEDAL STRAP(35) through the opening in the PEDAL CAP(34)
on the other side from the top as shown in the illustration 1, then make the end of the PEDAL STRAP(35)
go up to attach onto the upper part of the PEDAL STRAP(35) with the Hook & Loop Pad.
Attach the end of the PEDAL STRAP(35) to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
1.
Hook & Loop Pad

MAINTENANCE

The safety and integrity designed into the BodyTrac Glider 1060 can only be maintained when the
BodyTrac Glider 1060 is regularly examined for damage and wear. Special attention should be given to
the following:
1. Pull on the HANDLEBARS(17, 18) and verify that the SHOCK(22) provides tension.
2. Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(62) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(62) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the BodyTrac Glider 1060 removed
from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the BodyTrac Glider
1060.
8. Keep your BodyTrac Glider 1060 clean by wiping it off with an absorbent cloth after use.
HOT
after a few minutes of use.
Knot
End of Pedal Strap
13
Adjustment
Knob
Mark
Hook & Loop Pad
2.