Assembly Instructions - Stamina BODYTRAC GLIDER 1060 Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Service section and order the part needed,
e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the U.S.).
Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central Time) Monday
through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
STEP 1
Lay the Main Frame Assembly on the floor as shown in the illustration. Now refer to inset drawing A. Make
sure the Key Rib in the STABILIZER CAP(5) aligns with the slot in the REAR SUPPORT(4), then press
the STABILIZER CAP(5) onto the REAR SUPPORT(4).
STEP 2
Connect the EXTENSION WIRE(39) to the SENSOR WIRE(40). Then insert the FRONT SUPPORT(26)
into the SLEEVE(25) which in inside of the CENTER BEAM(1) and secure with the SUPPORT PLATE(23),
BUTTON HEAD BOLTS(M8x1.25x25mm)(53), LOCK WASHERS(M8)(61), and WASHERS(M8)(59).
STEP 3
Turn the Main Frame Assembly to the normal upright position.
sides of the CENTER BEAM(1) with BUTTON HEAD BOLTS(M8x1.25x25mm)(53).
Attach the SEAT STOPPERS(3) to both
7
A.
Key Rib