Configuration Example; Configuring Pq - HP A6600 Configuration Manual

To do...
3. Configure the FIFO queue size.

Configuration example

# Set the FIFO queue size to 100.
<Sysname> system-view
[Sysname] interface ethernet 1gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] qos fifo queue-length 100

Configuring PQ

The PQ configuration is not available on a SAP interface card working in bridge mode.
Define multiple rules for a PQL and apply the list to an interface. When a packet arrives at the interface, the
system matches the packet with each rule in the order configured. If a match is found, the packet is assigned
to the queue and the match procedure is complete. If the packet cannot match any rule, the packet is
assigned to the default queue normal.
Configure PQ by applying a PQ list to an interface. For an interface, the latest applied PQ list overwrites the
previous one.
You must enable the line rate function for the queuing function to take effect on these interfaces: tunnel
interfaces, subinterfaces, Layer 3 aggregate interfaces, HDLC link bundle interfaces, RPR logical interfaces,
and VT interfaces configured with PPPoE, PPPoA, or PPPoEoA encapsulation.
To do...
1. Enter system view.
2. Configure a PQ list.
3. Specify the default queue for
the PQ list.
4. Set the queue size.
Command...
interface atm
Enter PVC
interface-number
view
pvc vpi/vci
qos fifo queue-length
queue-length
Command...
system-view
qos pql pql-index protocol ip [ queue-key
key-value ] queue { bottom | middle |
normal | top }
qos pql pql-index default-queue { bottom |
middle | normal | top }
qos pql pql-index queue { bottom | middle |
normal | top } queue-length queue-length
Remarks
Required.

1024 for the GE interface of an A6602
router or an FIP-210/SAP interface card.

1024 for the POS interface of an A6602
router or an FIP-210 interface card.

75 for any other interface.
52
Remarks
—
Required.
Optional.
This command specifies
the queue to which
unmatched packets are
assigned.
Optional.