Auto Roast - GE JE1555T Use And Care Manual

Automatic Roasting
AUTO ROAST uses the
temperature probe to cook to
the desired serving temperature.
Unlike TEMP COOK/HOLD,
which uses a single power level,
AUTO ROAST uses up to 3 power
settings which automatically
switch during roasting, thus
providing even, tender cooking
results without overcooking.
Just as in conventional roasting,
only tender roasts should be Auto
Roasted. Less tender roasts should
be microwaved by time, according
to the cookbook which comes with
your oven.
Preparing Roasti and
Poultry for Auto Roasting
Place beef roasts and poultry on
trivet in microwave-safe dish. Pork
and ham roasts do not require a
trivet. Make sure probe handle
does not touch the food, top, or
sides of the oven.
Place beef roasts (bone-in cuts) on
trivet in microwave-safe dish with
the eye facing up and down. Insert
probe into the center of the eye
from the side of the roast not
touching bone or fat. Cover tightly
with plastic wrap.
Place beef roasts (boneless cuts) on
trivet in microwave-safe dish with
the eye facing left and right. Insert
probe into the center of the eye from
the side of the roast not touching fat.
Cover tightly with plastic wrap.
Place whole poultry on trivet in
microwave-safe dish. Insert probe
into meatiest area of inner thigh
from below end and parallel to leg.
Cover tightly with plastic wrap.
Ham and pork roasts need no
trivet. Add 1/2 cup water to
microwave-safe roast dish. Insert
probe from the side into the ham
and cover with wax paper. Insert
probe from the side into pork roast
and cover tightly with plastic wrap.
Place food in oven and insert cable
end of probe firmly into receptacle
in top center of oven.
How to Auto Roast
Beef to Medium
1. Touch AU~ ROAST pad.
on display and "ENTER CODE"
flashes. Touch number pad 2.
"CODE 2" appears on display and
"START" flashes. Touch START.
Display shows "COOL" and
7
"CODE 2'
2. At 90°F., display switches to
show meat's internal temperature.
3. After approximately 1/3 to 1/2 of
total roasting time, the oven signals
with 4 beeps and "TURn" will
flash on the display. Open door,
disconnect probe from receptacle
and remove dish. Discard plastic
wrap, turn roast (without removing
the probe from the meat) and
rewrap in plastic. Reinsert cable
end of probe into receptacle. Close
door and touch START; food
temperature appears on the display.
(Oven continues to cook after the
signal whether or not roast is
turned over.) At the TURn signal,
shield poultry if necessary. No turn
is needed.
4. After the pre-programmed food
temperature is reached, oven beeps
4 times and "End" is displayed.