Setting Notification Sound - Kenwood TH-D74A User Manual

Reply To Callsign
When there is a message you would like to reply to for
the specific Callsign, preset that Callsign for automatic
responses.
1 Access Menu No. 562.
2 Enter the Callsign.
A reply will be sent to all matching stations when
•
using the wildcard mark ( ).
For example, if you enter JA1 , a response is
sent to all Callsigns beginning with JA1.
Reply Delay Time
After a message has been received, if you operate the
transceiver during the delay time, before the message is sent,
the auto-reply message is canceled. You can set the wait
time as 0, 10, 20, 30, or 60 seconds. The default setting is 10
seconds.
1 Access Menu No. 563.
2 Select [0], [10], [20], [30], or [60] seconds.
When a message is received before the delay
•
time has completed counting down, the timer will
reset and begin counting down again.
• When multiple messages are received from the same
caller before the delay time has completed counting
down, only one message will be sent through auto-reply
message.
• When the delay time is set to 0 seconds, auto-reply
message will send a response immediately following an
acknowledged received message.
Reply Message Text
1 Access Menu No. 564.
2 Enter the message text.
• The display for entering a message appears; the first
digit blinks.
• You can enter alphanumeric characters plus special
ASCII characters.

SETTING NOTIFICATION SOUND

RX Beep Type
This transceiver beeps each time it receives any type of
APRS packets.
1 Access Menu No. 570.
2 Select [Off], [Message Only], [Mine], [All New], or [All].
[Off]: The APRS beep tone does not sound.
[Message Only]: Beep sounds only when a message is
received at your station address.
[Mine]: Beep sounds when a message is received at your
station address and your transmitted data is received by a
digipeater.
[All New]: Beep sounds when a message is received at
your station address and new packet data is received.
[All]: Beep sounds when a message is received at your
station address and duplicate data or invalid data is
received.
TX Beep
When your beacon is transmitted in a manner other than
manually, you can select whether or not it emits a beep
sound.
1 Access Menu No. 571.
2 Select [Off] or [On].
[Off]: A beep does not sound.
[On]: A beep sounds when a beacon is transmitted using
[PTT] or when it is automatically transmitted. When auto-
reply message sends a response, a beep will sound.
Special Call
This function emits a special call sound when receiving an
APRS message from a specific station.
1 Access Menu No. 572.
2 Set the Callsign (including SSID) of the station from which
you want to receive a special call notification.
14-20