A Eva4400 Cabling Diagrams; Connecting Device Port Fibre Channel Cables To The Eva4400 (Rear View) - HP StorageWorks 4400 Installation Manual

A EVA4400 cabling diagrams

This appendix contains cabling diagrams for common EVA4400 installation environments. If you plan
to configure the EVA4400 with an iSCSI device, see the HP StorageWorks EVA iSCSI connectivity
user guide. See
Connecting device port Fibre Channel cables to the EVA4400
(rear view)
This section shows two views of how you can connect cables to the controller.
controller mounted on top of the disk shelves in the rack, and
shelves mounted above and below it.
1. For configurations with the controller above the disk enclosures, attach the cables to the EVA as
shown in
NOTE:
All controller device port A cabling must be plugged into the A I/O modules on all enclosures.
All controller B device port cabling must be plugged into the B I/O modules on all enclosures.
Related documentation
Figure 22.
HP StorageWorks 4400 Enterprise Virtual Array installation guide
for the location of this guide.
Figure 23
Figure 22 shows the
shows the controller with disk
81