Cabling The Hpe Storeeasy 1000 Storage To The Network; Cabling The Hpe Storeeasy 1460 Storage To The Network; Cabling The Hpe Storeeasy 1560 Storage To The Network - HP HPE StoreEasy 1000 Getting Started Manual

3. Cabling the HPE StoreEasy 1000 Storage to the network

Procedure

1. Cabling the HPE StoreEasy 1460 Storage to the network

2. Cabling the HPE StoreEasy 1660 Storage and HPE StoreEasy 1860 Storage to the network

3. Cabling the HPE StoreEasy 1560 Storage to the network

4. Cabling the HPE StoreEasy 1660 Expanded Storage to the network
Cabling the HPE StoreEasy 1460 Storage to the network
The iLO network port is used to remotely manage the HPE StoreEasy 1000 Storage hardware and allows administrators
to launch a remote console session to the system. HPE recommends that you connect the iLO port to your management
network. The iLO port is pre-configured to obtain an IP address through DHCP. If your environment does not support
DHCP, use a KVM and configure iLO to use a static IP address.
The 4 x 1GbE network ports are used for the storage network and to connect the system to infrastructure services such
as, Active Directory, DNS, NTP, and so on. The ports can be configured as segregated network ports or a network team.
Ensure that your switch is prepared for either configuration.
1
Figure 5: Rear view of the HPE StoreEasy 1460 Storage
Where,
1. Network Ports
2. iLO Port
If you have purchased additional interface cards for your HPE StoreEasy 1000 Storage, the following table guides you on
where to install them. The numerical values indicate the order of installation.
Description
PCIe Slot 1 (x16) (Primary
Riser)
PCIe Slot 2 (x8) (Primary
Riser)
PCIe Slot 3 (x16)
1
(Secondary Riser
FlexLOM Slot
1
Slot for Secondary Riser requires the second processor to be installed.
Cabling the HPE StoreEasy 1560 Storage to the network
The iLO network port is used to remotely manage the HPE StoreEasy 1000 Storage hardware and allows administrators
to launch a remote console session to the system. HPE recommends that you connect the iLO port to your management
2
PCIe x8
2
1
3
)
Not available
PCIe x16
1
Not available
2
Not available
FlexLOM
Not available
Not available
X
21
Setup and install