Connecting Through A Private Network; Management Module - HP StorageWorks 4400 Installation Manual

Figure 18 management module
4.
Temporarily connect a LAN cable from a private network to the management module. A laptop
computer works well for this.
5. From a computer on the private network, browse to https://192.168.0.1:2373 and log in as an
administrator. The user name is admin. No password is required. The WOCP GUI appears.
IMPORTANT:
Previously the WOCP used port 2372 but now uses 2373.
6. Select Administrator Options > Configure Network Options.
7. Enter an IP address and other network settings that apply.
NOTE:
If you configure the management module in the 10.0.0.x network, do not use 10.0.0.1, 10.0.0.2,
or 10.0.0.3 as the IP address for the management module or any device connected to the
management module. These addresses are used by the management module.
8. Click Save Changes. The IP address changes immediately, causing you to lose connectivity to
the WOCP. You cannot save changes if the EVA4400 storage system has not been initialized.
9.
Remove the LAN cable to the private network and reconnect the cable to the public network.
The new IP address is stored and remains in effect, even when the storage system is shut down
or restarted. However, the IP address will be lost if the storage system is uninitialized and the
WOCP reset.
10. From a computer on the public network, browse to https://newly configured ip ad-
dress:2373 and log in as an administrator. The user name is admin. No password is required.
The WOCP GUI appears.
NOTE:
If the password for either the administrator or user account is changed, it should be recorded
since it cannot be cleared without performing a complete reset of the WOCP.

Connecting through a private network

Use this procedure when the management module will not be connected through a public network or
the array has not yet been initialized.
1. Press and hold the recessed Reset button for 4–5 seconds (2
of 192.168.0.1. The amber indicator on the top right corner of the Ethernet jack (1,
will flash momentarily when the reset operation is completed.
44 Connecting to the management module
Figure 18). This sets an IP address
Figure 18)