Setting Up Networks; Configuring The Private Network Adapter; Configuring The Public Network Adapter; Renaming The Local Area Connection Icons - HP StorageWorks X1800sb - Network Storage Blade User Manual

Setting up networks

Verify that all network connections are correct, with private network adapters connected to other
private network adapters only, and public network adapters connected to the public network.

Configuring the private network adapter

The following procedures are best practices provided by Microsoft and should be configured on the
private network adapter.
• On the General tab of the private network adapter, ensure that only TCP/IP is selected.
• Ensure that the Register this connection's address in DNS is not selected in the DNS tab under
advanced settings for Internet Protocol (TCP/IP) Properties.
• In all cases, set static IP addresses for the private network connector.

Configuring the public network adapter

While the public network adapter's IP address can be automatically obtained if a DHCP server is
available, this is not recommended for cluster nodes. HP strongly recommends setting static IP addresses
for all network adapters in the cluster, both private and public. If IP addresses are obtained though
DHCP, access to cluster nodes could become unavailable if the DHCP server goes down. If DHCP
must be used for the public network adapter, use long lease periods to assure that the dynamically
assigned lease address remains valid even if the DHCP service is temporarily lost. Keep in mind that
Cluster service recognizes only one network interface per subnet.

Renaming the local area connection icons

HP recommends changing the names of the network connections for clarity. The naming helps identify
a network and correctly assign its role. For example, "Cluster interconnect" for the private network
and "Public connection" for the public network.

Verifying connectivity and name resolution

To verify name resolution, ping each node from a client using the node's machine name instead of
its IP address.

Verifying domain membership

All nodes in the cluster must be members of the same domain and able to access a domain controller
and a DNS Server.

Setting up a cluster account

The Cluster service requires a domain user account under which the Cluster service can run. This user
account must be created before installing Cluster service, because setup requires a user name and
password. This user account should be a unique domain account created specifically to administer
this cluster. This user account will need to be granted administrator privileges.

About the Quorum disk

HP makes the following Quorum disk recommendations:
68 Cluster administration