Power Up With The Multiport Cable - VeriFone MX 880 Installation Manual

Power Up with
the Multiport
Cable
NOTE
WARNING
NOTE
The power outlet
This section describes how to connect the MX 800 Series terminal to a power
source using the multiport cable.
If connected to an ECR, the MX 800 Series terminal can receive power from the
ECR.
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
The power outlet should be on a dedicated circuit or on an uninterruptible power
supply (UPS). If other devices are plugged into the same circuit, the MX 800
Series device can potentially experience power fluctuations that might cause it to
malfunction.
1
Make all other connections before connecting the power pack.
2
Insert the multiport cable connector into the port on the back of the terminal
and secure with the tie-down strap (see
3
Route the cable through the slots to the desired exit side.
4
Insert the plug from the power pack into the +12V receptacle on the multiport
cable.
Figure 18).
MX 800 S I
ERIES NSTALLATION
21
G
UIDE