General Safety Rules - Weston 08-0801-W User Manual

GENERAL SAFETY RULES

READ AND FULLY UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
PRIOR TO USING THIS UNIT. YOUR SAFETY IS MOST IMPORTANT!
FAILURE TO COMPLY WITH PROCEDURES AND SAFE GUARDS MAY
RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. REMEMBER:
YOUR PERSONAL SAFETY IS YOUR RESPONSIBILITY!
1. DO NOT use the Grinder without the Tray/
Safety Guard secured into place.
ALWAYS DISCONNECT Grinder from power
2.
source before servicing, changing accessories or
cleaning the unit.
3. Plug the Grinder into a standard 120 Volt, 60
Hz wall outlet. Check if the voltage indicated on the
appliance corresponds to the local voltage before
you connect the appliance.
4. DO NOT USE the Grinder if the Power Cord,
Plug or any other parts are damaged. If the Power
Cord or the Grinder is damaged, call Customer
Service. DO NOT ATTEMPT TO REPLACE THE
CORD. Be sure to not allow the Power Cord
to drape into your work area. Check that all parts
are operating properly, and perform the intended
functions. Check for alignment of moving parts or
any other conditions that may affect the operation.
NEVER use any accessories or parts from
5.
other manufacturers. Doing so will VOID YOUR
WARRANTY and may cause fire, electrical shock or
injury.
6. TO PROTECT
ELECTRICAL SHOCK: DO NOT SUBMERGE THE
MAIN GRINDER BODY INTO WATER OR LIQUID.
BE SURE THE GRINDER IS DISCONNECTED
FROM THE
CLEANING. Wash all parts by hand and thoroughly
dry. Thoroughly clean all parts that will come
in contact with food before using the appliance.
NEVER rinse appliance Grinder Motor under tap,
only use a moist cloth to clean the Grinder Motor
Unit.
7. Reduce risk of unintentional starting. Make
sure the Power Switch is in the "OFF" position
before attaching to the power source.
8. KEEP FINGERS CLEAR of the Auger and
Cutting Blades AT ALL TIMES. NEVER REACH
INTO THE GRINDER, doing so may cause serious
injury. ALWAYS USE THE PROVIDED STOMPER,
NEVER FEED FOOD BY HAND.
9. NEVER use fingers to scrape food away from
the Grinding Plate while the Grinder is in operation.
SEVERE INJURY MAY RESULT.
10. NEVER
UNATTENDED.
Grinder from power source before leaving the work
area. Close supervision is necessary when any
appliance is used near children. This appliance is
NOT to be used by children.
4
AGAINST RISK
POWER SOURCE BEFORE
OPERATE THE GRINDER
Be safe, DISCONNECT the
SAVE THESE INSTRUCTIONS
11. Avoid contact with moving parts. Wait until all moving
parts have stopped before you remove any part of the
Grinder.
TIE BACK loose hair and clothing, and roll up long
.
sleeves before operating the Grinder. REMOVE ties, rings,
watches, bracelets, or other jewelry before operating the
Grinder.
13. Be sure the Grinder is on a stable work surface. Be
sure all the Grinder Feet are stable.
14. DO NOT attempt to grind bones, nuts or other hard
items. DO NOT let cord come in contact with a hot surface.
DO NOT use on an oven or stove. Check if the voltage
indicated on the appliance corresponds to the local voltage
before you connect the appliance.
15. DO NOT run Grinder without meat in the Head.
Severe damage to the Head and Auger may occur.
16. WEAR EYE PROTECTION. Wear safety glasses.
Everyday eye glasses are not safety glasses.
glasses conform to ANSI Z87.1 requirements.
approved safety glasses have Z87 printed or stamped on
them.
OF
17. DO NOT use outdoors.
18. DO NOT use the Grinder while under the influence of
drugs, medications or alcohol.
19. DO NOT let the Power Cord hang over edge of work
surface.
DO NOT attempt to operate the Grinder if the
20.
Grinder itself is cold. The Grinder temperature should be
at least 45 F (7 C) before beginning.
o o
21. The Gear Housing and the Motor Cover may
become HOT during operation. This is normal. DO NOT
touch these parts during operation or until they cool after
use.
22. WARNING: Busted, splintered bones can get into the
digestive tract of a pet and cause severe damage, even
death by puncturing the walls of the intestines or even
stomach
23. Weston Pro Series Electric Meat Grinders (#22 and
#32) are capable of grinding smaller, softer animal bones
such as rabbit, whole chickens* or chicken quarters, and
other birds, due to both the power and all metal construction
of the units.
24. Avoid grinding large, dense animal bones as they are
very difficult to process (i.e., bones one would find in large-
game, pigs, or cows).
Safety
Note: