Grinder Assembly Instructions - Weston 08-0801-W User Manual

GRINDER ASSEMBLY INSTRUCTIONS

WARNING!
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Insert the Head into the Gear
Housing with the Feed Chute facing
straight up. You will need to line up
the slot in the Head with the Pin inside
the Gear Housing. Be sure the Head
is seated fully into the Gear Housing
(Figure 1).
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(Figure 2). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the Auger
Bearing for wear. If the Auger Bearing
has excessive wear, replace it to
prevent head damage.
4. Place the Knife onto the square
part of the Auger Pin (Figure 2). Be
sure the blades of the Knife are facing
outward.
5. Place one of the Grinder Plates
onto the Auger Pin; align the notch in
the Grinder Plate with the Pin in the
Grinder Head.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring
Nut until it makes contact with the
Grinder Plate, then make 1/4 turn
more to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 3).
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 3).
REFER TO "GRINDING
INSTRUCTIONS"
WARNING!
See Safety
Guard
Instructions
Prior
Operation!
10
Before cleaning, assembling or disassembling the
Head
Slot in Head
Feed
Chute
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
Knife
Grinder Plate
Front Ring
Nut
NOTE! Be sure the blades
of the Knife are facing out.
Tray
Neck
Feed
Chute
Head
FIGURE 1
Head Locking
Knob
FIGURE 2
Head
FIGURE 3