Standard Stuffer Assembly Instructions - Weston 08-0801-W User Manual

STANDARD STUFFER ASSEMBLY INSTRUCTIONS

WARNING!
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Insert the Head into the Gear
Housing with the feed chute of the
Head facing straight up. You will need
to line up the slot in the Head with the
Pin inside the Gear Housing. Be sure
the Head is seated fully into the Gear
Housing. (FIGURE 5)
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 6). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the Auger
Bearing has excessive wear, replace
it to prevent head damage.
4. Slide the Stuffing Star over the
round portion of the Auger Pin.
5. Slide one of the Stuffing
Funnels through the Flange and
place it through the Front Ring
Nut.
6. Install the Front Ring Nut, DO NOT
OVERTIGHTEN. Turn the Front Ring
Nut until it makes contact with the
Flange, then make 1/4 turn more to
tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 7).
8. NEVER operate Grinder without
the Tray secured in place (FIGURE 7).
REFER TO "STUFFING
INSTRUCTIONS"
WARNING!
See Safety
Guard
Instructions
Prior
Operation!
12
Before cleaning, assembling or disassembling the
Head
Slot in Head
Feed
Chute
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
Flange
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 5
Head Locking
Knob
FIGURE 6
Head
FIGURE 7