Important Safety Rules - Weston 08-0801-W User Manual

IMPORTANT SAFETY RULES

READ AND FULLY UNDERSTAND ALL INSTRUCTIONS
AND WARNINGS PRIOR TO USING THIS UNIT. YOUR
SAFETY IS MOST IMPORTANT! FAILURE TO COMPLY
WITH PROCEDURES AND SAFEGUARDS MAY RESULT
WARNING!
IN SERIOUS INJURY OR PROPERTY DAMAGE.
REMEMBER: YOUR PERSONAL SAFETY IS YOUR
RESPONSIBILITY!
1. DO NOT use the Grinder without the Tray/Safety
Guard secured into place.
2. ALWAYS DISCONNECT Grinder from power
source before servicing, changing accessories or
cleaning the unit.
3. Plug the Grinder into a standard 120 Volt, 60
Hz wall outlet. Check if the voltage indicated on the
appliance corresponds to the local voltage before you
connect the appliance.
4. DO NOT USE the Grinder if the Power Cord,
Plug or any other parts are damaged. If the Power
Cord or the Grinder is damaged, call Customer
Service. DO NOT ATTEMPT TO REPLACE THE
CORD. Be sure to not allow the Power Cord to drape
into your work area. Check that all parts are operating
properly, and perform the intended functions. Check
for alignment of moving parts or any other conditions
that may affect the operation.
5. NEVER use any accessories or parts from
other manufacturers. Doing so will VOID YOUR
WARRANTY and may cause fi re, electrical shock or
injury.
6. TO PROTECT AGAINST RISK OF ELECTRICAL
SHOCK: DO NOT SUBMERGE THE MAIN GRINDER
BODY INTO WATER OR LIQUID. BE SURE THE
GRINDER IS DISCONNECTED FROM THE POWER
SOURCE BEFORE CLEANING. Wash all parts by
hand and thoroughly dry. Thoroughly clean all parts
that will come in contact with food before using the
appliance. NEVER rinse appliance Grinder Motor
under tap, only use a moist cloth to clean the Grinder
Motor Unit.
7. Reduce risk of unintentional starting. Make sure
the Power Switch is in the "OFF" position before
attaching to the power source.
8. KEEP FINGERS CLEAR of the Auger and
Cutting Blades AT ALL TIMES. NEVER REACH
INTO THE GRINDER, doing so may cause serious
injury. ALWAYS USE THE PROVIDED STOMPER,
NEVER FEED FOOD BY HAND.
9. NEVER use fi ngers to scrape food away from
the Grinding Plate while the Grinder is in operation.
SEVERE INJURY MAY RESULT.
10. NEVER OPERATE THE
UNATTENDED. Be safe, DISCONNECT the Grinder
from power source before leaving the work area. Close
supervision is necessary when any appliance is used
near children. This appliance is NOT to be used by
children.
11. Avoid contact with moving parts. Wait until all
moving parts have stopped before you remove any
part of the Grinder.
SAVE THESE INSTRUCTIONS!
Refer to them often and use them to instruct others.
12. TIE BACK loose hair and clothing, and roll up
long sleeves before operating the Grinder. REMOVE
ties, rings, watches, bracelets, or other jewelry before
operating the Grinder.
13. Be sure the Grinder is on a stable work surface.
Be sure all the Grinder Feet are stable.
14. DO NOT attempt to grind bones, nuts or other hard
items. DO NOT let cord come in contact with a hot
surface. DO NOT use on an oven or stove. Check
if the voltage indicated on the appliance corresponds
to the local voltage before you connect the appliance.
15. DO NOT run Grinder without meat in the Head.
Severe damage to the Head and Auger may occur.
16. WEAR EYE PROTECTION. Wear safety glasses.
Everyday eye glasses are not safety glasses. Safety
glasses conform to ANSI Z87.1 requirements. Note:
approved safety glasses have Z87 printed or stamped
on them.
17. DO NOT use outdoors.
18. DO NOT use the Grinder while under the
infl uence of drugs, medications or alcohol.
19. DO NOT let the Power Cord hang over edge of
work surface.
20. DO NOT attempt to operate the Grinder if
the Grinder itself is cold. The Grinder temperature
o o
should be at least 45 F (7 C) before beginning.
21. The Gear Housing and the Motor Cover may
become HOT during operation. This is normal. DO
NOT touch these parts during operation or until they
cool after use.
22. WARNING: Busted, splintered bones can get into
the digestive tract of a pet and cause severe damage,
even death by puncturing the walls of the intestines or
even stomach
23. Weston Pro Series Electric Meat Grinders (#22
and #32) are capable of grinding smaller, softer animal
bones such as rabbit, whole chickens* or chicken
quarters, and other birds, due to both the power and
all metal construction of the units.
GRINDER
24. Avoid grinding large, dense animal bones as they
are very diffi cult to process (i.e., bones one would
fi nd in large-game, pigs, or cows). Avoid grinding
large, dense animal bones as they are very diffi cult
to process (i.e., bones one would fi nd in large-game,
pigs, or cows).
25. Avoid grinding large, dense animal bones as they
are very diffi cult to process (i.e., bones one would fi nd
in large-game, pigs, or cows).
-3-