Connecting Front Speakers That Support Bi-Amp Connections - Yamaha RX-V6671 Owner's Manual

Table of Contents

Advertisement

1 2
3 4 5 6 7 8 9
Speaker connections
Connecting speaker cables
Speaker cables have two wires. One is for connecting the
negative (-) terminal of the unit and the speaker, and the
other is for the positive (+) terminal. If the wires are colored
to prevent confusion, connect the black wire to the
negative and the other wire to the positive.
1 Remove approximately 10 mm of insulation from the
ends of the speaker cable, and twist the bare wires of the
cable together firmly.
2 Loosen the speaker terminal.
3 Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
4 Tighten the terminal.
+ (red)
F R
O N
T
– (black)
Using a banana plug
1 Tighten the speaker terminal.
2 Insert a banana plug into the end of the terminal.
F R
O N
T
Banana plug
Push-type speaker terminals
1 Remove approximately 10 mm of insulation from the
ends of the speaker cable, and twist the bare wires of the
cable together firmly.
2 Press down the tab.
3 Insert the bare wires of the cable into the hole in the
terminal.
4 Release the tab.
E X
Z O
+ (red)
N
P R
– (black)
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Audio pin cable
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set "Power Amp Assign"
(p.90) in the "Setup" menu to "5ch BI-AMP" after
connecting the power cable to an AC wall outlet.
This unit (rear)
SPEAKERS
R
FRONT
L
CENTER
R
SURROUND
L
SURROUND BACK/BI–AMP
R
L
SINGLE
SINGLE
R
SUBWOOFER
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. When not making
bi-amp connections, make sure that the brackets or cables are
connected before connecting the speaker cables.
• When using bi-amp connections, surround back speakers
cannot be used.
L
EXTRA SP
ZONE 2/
PRESENCE
19
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-v671Rx-a710

Table of Contents