Multi Zone; Function; Zone2 Out - Yamaha RX-V6671 Owner's Manual

Multi Zone

Configures the multi zone settings.
■
Zone2 Set
Configures the audio output settings for Zone2.
• The "Zone2 Set" settings are available only when "Power Amp Assign" (p.90) is set to "7ch+1ZONE"
❑ Max Volume
Sets the Zone2 maximum volume so that sound is not too loud.
Setting range
-30.0dB ~ +15.0dB (5.0dB steps), +16.5dB
Default
+16.5dB
❑ Initial Volume
Sets the Zone2 initial volume for when this unit is turned on.
Settings
Off (default) Sets at the level when this unit last entered standby mode.
Sets at Mute, or -80.0dB ~ +16.5dB (0.5dB steps).
On
(This setting works only when "Max Volume" is set higher.)
■
Zone Rename
Changes the zone names displayed on the TV screen.
■
Setup procedure
1
Use the cursor keys to select a zone to be renamed and press ENTER.
2
Press ENTER, use the cursor keys to rename, and then press ENTER again.
3
Use the cursor keys to select "OK" and press ENTER.
• To clear the entry, select "CLEAR".
4
To exit from the menu, press ON SCREEN.

Function

Configures the functions that make this unit easier to use.
■
Auto Power Down
Sets the amount of time for auto-standby. If you do not operate this unit for the specified
time, this unit will automatically go into standby mode.
Settings
Off (default) Does not set this unit to standby mode automatically.
4 Hours, 8 Hours, Sets this unit to standby mode when you have not operated this unit for the
12 Hours specified time.
97
En