Connecting Front Speakers That Support Bi-Amp Connections - Yamaha RX-V779 Owner's Manual

1 2 3 4 5 6 7 8 9 10 11
Push-type speaker terminals
(RX-V679 only)
a Remove approximately 10 mm (3/8") of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
b Press down the tab.
c Insert the bare wires of the cable into the hole in the
terminal.
d Release the tab.
E X
Z O
T R
N E
A S
2 /F
P
.P R
E S
a a E N
C E
d b
+ (red)
c
- (black)
■
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Audio pin cable
C E N
TE R
FR O
N T
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set "Power Amp Assign"
(p.104) in the "Setup" menu to "5ch BI-AMP" after
connecting the power cable to an AC wall outlet.
ZONE2/F.PRESENCE
The unit (rear)
SPEAKERS
CLASS 2 WIRING CABLAGE CLASSE 2
SURROUND CENTER FRONT
SURROUND BACK/BI-AMP
1
2
SUBWOOFER
1 2
3
9
4
• The FRONT jacks and SURROUND BACK/BI-AMP jacks output the
same signals.
23
En
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
EXTRA SP
SINGLE
5