1
2 3 4 5 6 7 8 9
Speaker placement
■
Setting the speaker impedance
This unit is configured for 8-ohm speakers at the factory. When connecting 6-ohm
speakers, set the speaker impedance to "6 Ω MIN". In this case, you can also use 4-
ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press MAIN
ZONE
.
MAIN ZONE
STRAIGHT
3
Check that "SP IMP." is displayed on the front display.
SP IMP. -8 MIN
4
Press STRAIGHT to select "6 Ω MIN".
5
Press MAIN ZONE
to set this unit to standby mode and remove
the power cable from the AC wall outlet.
Now you are ready to connect the speakers.
16
En