Pairing This System With A Bluetooth Device - Sony MHC-GT4D Operating Instructions Manual

Pairing this system with
a BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with each
other beforehand. Once a pairing
operation is performed, it does not
need to be performed again.
1
Place the BLUETOOTH device
within 1 meter from the system.
2
Press BLUETOOTH on the
subwoofer to select BLUETOOTH
function.
"BT AUDIO" appears in the display
panel.
Notes

When there is no pairing information
on the system, the system enters the
pairing mode automatically and
"PAIRING" flashes in the display
panel. Proceed to step 4.

If the system is connected to a
BLUETOOTH device, press
BLUETOOTH on the subwoofer to
disconnect the BLUETOOTH device.
3
Hold down PAIRING on the
subwoofer for 2 seconds or more.
"PAIRING" flashes in the display
panel.
4
Perform the pairing procedure on
the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5
Select "MHC-GT4D" on the
device's display.
Perform this step within 5 minutes,
otherwise pairing will be canceled.
In this case, repeat from step 1.
GB
40
Note
If passkey is required on the
BLUETOOTH device, enter "0000".
"Passkey" may be called "Passcode",
"PIN code", "PIN number", or
"Password".
6
Perform the BLUETOOTH
connection on the BLUETOOTH
device.
The BLUETOOTH device name
appears in the display panel.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.
Notes

You can pair up to 9 BLUETOOTH
devices. If the 10th BLUETOOTH device is
paired, the oldest paired device will be
deleted.

If you want to pair with another
BLUETOOTH device, repeat steps 1 to 6.
To cancel pairing operation
Hold down PAIRING on the
subwoofer for 2 seconds or more until
"BT AUDIO" appears in the display
panel.
To delete pairing information
Use the buttons on the subwoofer to
perform this operation.
1
Press BLUETOOTH to select
BLUETOOTH function.
"BT AUDIO" appears in the display
panel.
If the system is connected to a
BLUETOOTH device, the BLUETOOTH
device name appears in the display
panel. Press BLUETOOTH to
disconnect the BLUETOOTH device.