Table of Contents
Advertisement
Turn off surrounding electrical
equipment.
* Radio may not be received depending
on the radio wave conditions or the
housing environment in your area.
BLUETOOTH device
Pairing cannot be performed.
Move the BLUETOOTH device closer
to the system.
Pairing may not be possible if other
BLUETOOTH devices are present
around the system. In this case, turn
off the other BLUETOOTH devices.
Make sure the correct passkey was
entered at the BLUETOOTH device.
The BLUETOOTH device cannot
detect the system, or "BT OFF"
appears in the display panel.
Set the BLUETOOTH signal to "BT ON"
(page 43).
Connection is not possible.
The BLUETOOTH device you
attempted to connect does not
support the A2DP profile, and cannot
be connected with the system.
Enable the BLUETOOTH function of
the BLUETOOTH device.
Establish a connection from the
BLUETOOTH device.
The pairing registration information
has been erased. Perform the pairing
operation again.
Erase the pairing registration
information of the BLUETOOTH
device (page 40) and perform the
pairing operation again (page 40).
The sound skips or fluctuates, or the
connection is lost.
The system and the BLUETOOTH
device are too far apart.
If there are obstacles between the
system and your BLUETOOTH device,
remove or avoid the obstacles.
If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other BLUETOOTH
device, or a microwave oven nearby,
move them away.
The sound of your BLUETOOTH
device cannot be heard on this
system.
Increase the volume on your
BLUETOOTH device first, then adjust
the volume using
There is severe hum, noise, or
distorted sound.
If there are obstacles between the
system and your BLUETOOTH device,
remove or avoid the obstacles.
If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other BLUETOOTH
device, or a microwave oven nearby,
move them away.
Turn down the volume of the
connected BLUETOOTH device.
The sound from "Voice Playback" in
"Fiestable" application does not
output.
The built-in sound demonstration is
activated, press to stop the
demonstration. Then, perform the
playback again.
Control for HDMI ("BRAVIA"
Sync)
The system does not turn on even
when the TV is turned on.
Set [HDMI SETUP] – [CONTROL FOR
HDMI] to [ON] (page 35). The TV must
support the Control for HDMI
function (page 48). For details, refer
to the operating instructions of your
TV.
Check the speaker settings of the TV.
The system power syncs with the
speaker settings of the TV. For
details, refer to the operating
instructions of your TV.
+/–.
59
GB
Hide quick links:
Advertisement
Table of Contents
