Screws - Sony MHC-GT4D Operating Instructions Manual

Installing the speaker units
on a wall
Notes

Use screws (not supplied) that are
suitable for the wall material and
strength. As a plaster board wall is
especially fragile, attach the screws
securely to a wall stud. Install the
speaker system on a vertical and flat
reinforced area of the wall.

Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during
the installation.

Sony is not responsible for accidents or
damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
back of the speaker system.
More than 25 mm
Hole on the back of the speaker
system
5 mm
5 mm
10 mm
2
4 mm
3
Drive the screws to the wall.
The screws should protrude 6 mm
to 7 mm from the wall.
 To install the speaker units
horizontally
277 mm
6 mm to 7 mm
 To install the speaker units
vertically
6 mm to 7 mm
Hang the speaker system onto the

screws.

Align the holes on the back of the
speaker system to the screws, then
hang the speaker system onto the
screws.
 To install the speaker units
horizontally
277 mm
17 GB