BKI BLG Operation Manual page 17

Gas Pressure Fryer
Item Description
6 A, B, C, D preset
buttons
Beeper
Display
7 High Limit Reset Switch
8 Drain Lever
9 Fill Lever
10 Rinse Hose Connector
11 Pump Motor Reset Switch
12 Ignition Lock-out Light
13 Reset Switch
Function
These buttons are used to save and recall preset cycle and alarm times,
saving operator time and minimizing error when changing interval cycle
times and alarm times. To save the current interval and alarm times into
one of the preset locations, press and hold the A, B, C, or D preset button
for 2 seconds and the controller will double chirp to indicate the times have
been saved. To recall any preset time, press and quickly release the
appropriate button and the time values are loaded and displayed.
A beeper sounds when the timer counts down to 0. Pressing the
START/STOP button stops the beeper and resets the timer causing the
display to return to the original starting time. At this point, time can be
changed using the TIME SELECT buttons or the preset buttons. The
beeper will also sound for 10 seconds if the alarm time has elapsed during
a timing cycle. When the STIR OIL function begins the beeper will sound
until the ALARM or START/STOP button is pressed.
Used to display the time. It also displays the words "STIR" then "OIL" in .5
second intervals until the ALARM or START/STOP button is pressed.
Located under the control panel. If the heating elements inside the pot
reach an unsafe temperature, power is automatically removed from the
control panel, lift mechanism and elements. Pressing this switch returns
power to the control panel, left mechanism and elements.
DRAIN OPEN – When placed in this position, the drain valve opens and
shortening drains into the vat. Also power is removed from the control
panel and gas system.
DRAIN CLOSED – When placed in this position, the drain valve is closed
to prevent shortening from draining into the pot. Also power is restored to
the control panel and gas system.
FILL THRU POT – When placed in this position, shortening will be pumped
from the vat to the pot if the rocker switch is in the FILTER position.
FILL THRU HOSE – When placed in this position, shortening will be
pumped from the vat to the pot via a fill hose if the rocker switch is in the
FILTER position.
Used to connect the Rinse hose for cleaning and refilling the pot.
If the motor overheats while filtering, it will automatically shut off. Wait 15
minutes to allow motor to cool before pressing this switch.
Illuminates when the Ignition Module locks out during ignition.
Used to reset the Ignition Module when it locks out during ignition.
14
Operation