Adjusting The Throttle Wire; Replacing The Air Filter - Husqvarna Rider 11 R Operator's Manual

3 Tighten the locking nuts (1).
4 The brake should be checked again after adjustment
5 Assemble the left-hand wing cover.
WARNING! A poorly adjusted parking brake
!
can result in reduced braking ability.

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
3 Pull back the throttle to the full throttle position and check
that the choke is no longer actuated.
Replacing the air filter
If the engine seems to lack power or does not run smoothly
this may be because the air filter is clogged. It is therefore
important to replace the air filter at regular intervals (see
Maintenance/Maintenance Schedule for the correct service
interval).
Replace the air filter as follows:
1 Open the engine cover.
22 –
English
Maintenance
2 Pull up the handle on the air filter cover, unhook and turn
towards the engine.
3 Remove the air filter cover.
4 Lift out the air filter cartridge from the fan housing.
5 Replace the air filter cartridge, if clogged with dirt.
IMPORTANT INFORMATION
Do not use compressed air to clean the paper filter.
Do not oil the paper filter. They must be fitted dry.
6 Carefully lift the precleaner out of the fan housing.
7 Carefully clean the fan housing so that dirt does not fall
down into the carburettor.
8 Insert a new precleaner and air filter cartridge in the fan
housing.
9 Align the tabs on the cover with the slits in the housing and
replace the air filter cover.
10 Pull the handle outwards. Secure the handle in the air filter
cover and close the cover by pressing it inwards.