Solid State Drive - Dell Latitude E4200 Service Manual

Hide thumbs Also See for Latitude E4200:
Table of Contents

Advertisement

Back to Contents Page
  Solid State Drive
Dell™ Latitude™ E4200 Service Manual
  Removing the Solid State Drive and Cable Assembly
  Replacing the Solid State Drive and Cable Assembly
NOTE:
Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell.
 Removing the Solid State Drive and Cable Assembly
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
 
1. Follow the procedures in
Before Working on Your
 
2. Remove the service panel (see
 
3. Remove the two M2 x 3-mm screws securing the drive.
 
4. Lift the drive free from the alignment pins, and lift it out of the base assembly at an angle towards the middle of the computer.
 
5. Disconnect the Solid State Drive (SSD) cable from the system board by gently pulling on the connector release.
 
6. Gently slide the cable and connector from the end of the SSD. Carefully apply force to the connector and not the cable.
1 screws (2)

2 solid state drive

3 base assembly 4 alignment pins (2)
5 SSD cable
6 SSD connector release
 Replacing the Solid State Drive and Cable Assembly
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
 
1. Hold the drive with the label facing up.
 
2. Connect the SSD cable assembly to the SSD. Carefully align the connector to the replacement SSD and gently push the connector onto the device.
 
3. Gently connect the SSD cable to the system board using the connector release.
 
4. Lower the drive into the base assembly at an angle towards the outer edge of the computer and onto the alignment pins.
 
5. Replace the two M2 x 3-mm screws that secure the hard drive to the base assembly.
 
Computer.
Removing the Service
Panel).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents