Remote Keyless Entry (Rke) - Chevrolet cruze 2017 Owner's Manual

Table of Contents

Advertisement

Other conditions can affect the
performance of the transmitter. See

Remote Keyless Entry (RKE)

System 0 33.
Starting the Vehicle
To start the engine using the remote
start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release
3. Immediately after completing
Step 2, press and hold
least four seconds or until the
turn signal lamps flash. The
turn signal lamps flashing
confirms the request to remote
start the vehicle has been
received.
When the engine starts, the parking
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system may come on.
The engine will continue to run for
15 minutes. After 30 seconds,
repeat the steps if a 15-minute
extension is desired. Remote start
can be extended only once.
Place the ignition in ON/RUN/
START to drive.
Extending Engine Run Time
The engine run time can be
extended by another 15 mintues,
.
if during the first 15 minutes
Step 2 and 3 are repeated while the
engine is still running. An extension
for at
can be requested 30 seconds after
starting. When the remote start is
extended, the second 15-minute
period is added on to the first
15 minutes for a total of 30 minutes.
The remote start can be
extended once.
A maximum of two remote starts,
or a single start with an extension,
is allowed between ignition cycles.
The vehicle's ignition must be
turned on and then back off to use
remote start again.
Keys, Doors, and Windows
Canceling a Remote Start
To cancel a remote start, do one of
the following:
Aim the RKE transmitter at the
vehicle and press and hold
until the parking lamps turn off.
Turn on the hazard warning
flashers.
Turn the vehicle on and then off.
Conditions in Which Remote Start
Will Not Work
The remote vehicle start feature will
not operate if:
The key is in the ignition (Key
Access) or if the RKE transmitter
is in the vehicle (Keyless
Access).
The hood is not closed.
The hazard warning flashers
are on.
The malfunction indicator lamp
is on.
The engine coolant temperature
is too high.
The oil pressure is low.
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents