Adjusting The Cutting Height; Starting The Engine; Stopping The Engine - Toro 22291 Operator's Manual

Adjusting the Cutting Height

You can change the cutting height at each wheel by adjusting
a cutting-height lever. Cutting heights are 25 mm (1 inch), 38
mm (1-1/2 inches), 51 mm (2 inches), 64 mm (2-1/2 inches),
76 mm (3 inches), 89 mm (3-1/2 inches), 102 mm (4 inches),
114 mm (4-1/2 inches).
DANGER
Adjusting the cutting-height levers could bring your
hands into contact with a moving blade and result
in serious injury.
• Stop the engine and wait for all movement to
stop before adjusting the cutting height.
• Do not put your fingers under the housing when
adjusting the cutting height.
1. Pull the cutting-height lever toward the wheel (Figure
11) and move the lever to the desired setting.
1. Rear cutting-height lever (2)
2. Front cutting-height lever (2)
2. Release the cutting-height lever and seat it securely in
the notch.
3. Adjust all the wheels to the same cutting-height setting.
Figure 11

Starting the Engine

1. Connect the spark-plug wire to the spark plug.
2. Firmly push in the primer (Figure 12), holding the
primer bulb in for 1 second.
1. Primer
3. Hold the blade-control bar against the upper handle
(Figure 13).
1. Upper handle
4. Pull the starter handle lightly until you feel resistance,
pull it sharply, then allow it to return slowly to the rope
guide on the handle.
Note: If the engine does not start, repeat steps 2
through 4.

Stopping the Engine

Release the blade-control bar. Both the engine and the blade
should stop within 3 seconds. If they do not, contact an
Authorized Service Dealer.
13
Figure 12
Figure 13
2. Blade-control bar