Adjusting The Handle Height; Using The Mid-Size Weight Kit - Toro 30430 Operator's Manual

Adjusting the Handle Height

The handle position can be adjusted to match the operator's
height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Fig. 19).
1
2
4
5
6
7
8
Figure 19
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 19).
3. Remove the lower flange bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Fig. 19).
4. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
6. Check the parking brake adjustment; refer to Checking
the Brakes, page 31.
Using the Mid–Size Weight Kit
A weight kit is available for this machine. This kit is
optional and can be obtain from an Authorized Service
Dealer.
Installing this weight kit can improve performance on
slopes.
Note: For this machine, install the weight kit only in the
front position.
Note: The use of a Tru–Trak Sulky on this machine is not
recommended.
3
m–6591
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
23