Engine Oil - Toro 30164 Operator's Manual

Maintenance
2. Paper Element
A. Lightly tap the element on a flat surface to
remove dust and dirt (Fig. 24).
B. Inspect the element for tears, an oily film,
and damage to the rubber seal.
IMPORTANT: Never clean the paper element
with pressurized air or liquids, such as
solvent, gas, or kerosene. Replace the paper
element if it is damaged, defective, or cannot
be cleaned thoroughly.
1
Figure 24
1. Paper element
Installing the Foam and Paper Elements
1. Installing the Foam and Paper Elements
IMPORTANT: To prevent engine damage,
always operate the engine with the complete
foam and paper air cleaner assembly
installed.
1. Carefully slide the foam element onto the paper
air cleaner element (Fig. 22).
2. Place the air cleaner assembly onto the air
cleaner base (Fig. 22).
3. Install the air cleaner cover and secure with
cover nuts (Fig. 22).
28
2
2. Rubber seal

Engine Oil

Service Interval/Specification
Change oil:
After the first 5 operating hours.
After every 50 operating hours or every 25 hours
when operating under heavy load or in high
temperatures.
Note: Change oil more frequently when
operating conditions are extremely
dusty or sandy.
Oil Type: Detergent oil (API service SF, SG or SH)
Crankcase Capacity: 48 oz. (1.4 l)
Viscosity: See table below
USE THESE SAE VISCOSITY OILS
5W–30
10W–30
Synthetic
5W–20, 5W–30
–20 0 20
32
F
–30 –20 –10
C
SAE 30
80
40 60
0 10 20 30
100
40