Connect Throttle Cable - Toro 30164 Operator's Manual

3. Check the gap between upper control bar and
fixed bar with wheel drive fully engaged. Gap
should be approximately 1 to 1-1/4 in.
(25–32 mm) (Fig. 6).
Note: The upper control bar and fixed bar
must be parallel in the engaged,
relaxed and brake positions.
4. After completing assembly check operation. If
adjustment is required, remove hairpin cotter
securing rod to upper control bar. Thread rod in
or out of fitting for proper position and install
into upper control bar with hairpin cotter.
5. After adjusting control rods, check parking brake
adjustment, refer to: Brake page 36 for
instructions.
Figure 6
1. Control rod
2. Fixed control bar
m–3770
3. Parking brake lever
4. Upper control bar

Connect Throttle Cable

1. Place throttle control lever in FAST
position.(Fig. 7).
2. Hook wire Z–bend into hole of control plate
slide (Fig. 7).
3. Loosen cable clamp screw allowing cable
installation, but do not tighten (Fig. 7).
4. Move control cable until hole in contorl plate
slide is aligned with hole in control plate. Insert
a 1/8 in. (3.2 mm) diameter pin or bolt into
aligned holes to hold adjustment.
5. Pull throttle cable back slightly to remove any
slack and tighten cable clamp screw to lock
adjustment in place.
6. Remove alignment pin and check control
operation.
Figure 7
1. Control Plate Slide
2. Kill Switch
3. Choke Link
4. Alignment holes 1/8 in.
(3.2mm)
Assembly
5. Cable clamp
6. Control Cable
7. Contol Plate
15