Adjusting Grass/Mud Scraper; Replacing The Grass Deflector - Toro 30164 Operator's Manual

Maintenance

Adjusting Grass/Mud Scraper

1. Loosen the locknut holding scraper to the engine
frame (Fig. 52).
2. Rotate scraper until they align with center of
pulley grooves (Fig. 52).
3. Tighten the locknut (Fig. 52).
Note: The scraper must not contact the pulley
on the sides or bottom of grooves.
Re-adjust if necessary.
2
1
Figure 52
1. Scraper
2. Locknut
42
3
3. Pulley

Replacing the Grass Deflector

1. Remove the locknut, bolt, spring and spacer
holding deflector to the mounts (Fig. 53).
2. Straighten deflector mounts if they are bent
(Fig. 53).
3. Install new deflector between mounts with
spacer and spring. Place spacer through spring
and hook the front end of the spring around the
front deflector mount. Insert bolt through spacer
and secure with locknut. Confirm there is
downward spring force on deflector (Fig. 53).
4. Tighten the bolt and locknut until they lightly
contact the pivot brackets (Fig. 53).
IMPORTANT: The grass deflector must be
spring-loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
5
4
Figure 53
1. Deflector
2. Bolt
3. Deflector mount
6
3
1
m–3781
4. Spring
5. Spacer
6. Locknut
2