Dell PowerEdge R730xd Owner's Manual page 157

CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector and lift the
battery out of the socket.
Figure 74. Removing the system battery
1. system battery
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing
tabs.
4. Press the battery into the connector until it snaps into place.
Figure 75. Installing the system battery
1. system battery
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related Links
Safety instructions
Before working inside your system
Removing the cooling shroud
System board jumpers and connectors
Installing the cooling shroud
2. system battery slot
2. system battery slot
157