Toro 04042 Operator's Manual page 20

Kickstand
The kickstand (Figure 25) is mounted to the rear of the
machine and is used to raise the rear of the machine for
installation or removal of the transport wheels and to keep the
machine for falling onto the handle when you remove the reel.
•
To use the kickstand to install the transport wheels, lower
it to the ground and step down on the kickstand loop
while pulling up and back on the lower center machine
handle (Figure 24).
Important: Only put foot pressure down on the
kickstand loop, and only use the lower center
machine handle to raise the unit. Attempting to raise
the unit onto the kickstand by any other means can
cause injury.
Figure 24
1. Lower center machine
handle
g018793
2. Kickstand loop
1
2
1. Kickstand
•
To use the kickstand when removing the reel, lower it
and push in the locking pin to lock the kickstand in the
service position (Figure 26).
1
2
3
1. Kickstand—storage
position
2. Locking pin
20
G017246
Figure 25
2. Kickstand loop
Figure 26
3. Kickstand—service
position
G017356