Table of Contents
Advertisement
4
Installing the Battery Pack
Parts needed for this procedure:
1
Battery pack
6
Bolt (5/16 x 1/2 inch)
6
Washer
Procedure
1. Remove the battery pack from its carton, saving the
carton and all packing material for future use.
Important: Save the carton and all packing
materials. If you ever need to ship the battery for
maintenance, warranty, or recycling, you will need
this special packaging.
Refer to the Installation Instructions included
with the Battery Shipping Kit, 120-4600 (a PDF of
these instructions is available at no charge from
www.toro.com).
2. Cut the cable tie securing the battery charger to the
battery base on the machine and remove the charger.
3. Disconnect the small connector on the pack to machine
wiring harness from the main wiring harness (Figure
12).
4. Remove the tall nut that secures the rear of the battery
base to the machine frame (Figure 8).
1. Tall nut
5. Loosen the 2 pivot bolts/nuts a half turn each (Figure
9).
1
Figure 8
4
5
1. Battery pack
2. Battery platform
3. Bolt and washer
6. Raise the battery platform until the locking holes in the
base and frame align (Figure 9). Slide a screw driver or
other steel rod through the holes to hold the platform
in the raised position.
7. Place the battery pack on the base with the connector
port toward the rear of the machine.
8. Secure the battery pack to the base using 6 bolts (5/16
x 1/2 inch) and washers. Torque each bolt to 11.3 to
14 N-m (100 to 130 in-lb).
9. Line up the tabs on the inside of the harness power
plug with the slots in the battery pack receptacle. Press
the harness connector into the battery connector
(Figure 10 and Figure 11).
G017238
13
1
2
G017295
Figure 9
4. Pivot bolts
5. Locking holes
3
Advertisement
Table of Contents
