Adjusting The Carrier Frame; Adjusting The Height Of Cut - Toro Groundsmaster 3500-G Operator's Manual
Hide thumbs
Also See for Groundsmaster 3500-G:
- Operator's manual (56 pages) ,
- Operator's manual (52 pages) ,
- Operator's manual (16 pages)
Table of Contents
Advertisement
Figure 10
1. Rear cylinder
B.
Grasp the cylinder rod close to the nut with
a pliers and rag, and rotate the rod.
C.
Raise the cutting units and check the
clearance.
Note:
Repeat the procedure if required.
D.
Tighten the clevis jam nut.
Important:
Lack of clearance at the front stops or
rear wear bar could damage the lift arms.
5
Adjusting the Carrier Frame
No Parts Required
Adjusting the Front Cutting Units
The front and rear cutting units require different
mounting positions. The front cutting unit has 2
mounting positions depending on what height of cut
and degree of cutting unit rotation you desire.
1.
For heights of cut in the 2 to 7.6 cm (3/4 to 3
inches) range, mount the front carrier frames in
the lower, front mounting holes
Note:
This permits more up travel of the cutting
units relative to the machine when approaching
sudden changes in uphill terrain. It does,
however, limit the clearance of the chamber to
the carrier when cresting sharp, small hills.
g031575
2. Adjusting nut
(Figure
11).
1. Upper, front cutting unit
mounting hole
2. Lower, front cutting unit
mounting hole
2.
For heights of cut in the 6.3 to 10 cm (2-1/2 to 4
inches) range, mount the front carrier frames in
the upper, front mounting holes
Note:
This increases the chamber to carrier
clearance due to the higher position of the
cutting chamber, but causes the cutting unit to
reach its maximum up travel more quickly.
Adjusting the Rear Cutting Unit
The front and rear cutting units require different
mounting positions. The rear cutting unit has 1
mounting position for proper alignment with the
Sidewinder® unit under the frame.
For all heights of cut, mount the rear cutting unit in the
rear mounting holes
6
Adjusting the Height of Cut
No Parts Required
Procedure
Important:
This cutting deck often cuts
approximately 6 mm (1/4 inch) lower than a reel
cutting unit with the same bench setting. It may
be necessary to have the rotary cutting decks
13
Figure 11
3. Rear cutting unit mounting
hole
(Figure
(Figure
11).
g031576
11).
Advertisement
Table of Contents
