Table of Contents
Advertisement
Specifications
Note: Specifications and design subject to change without notice.
General Specifications
Configuration
Height of Cut
Construction
Blades
Cutter Drive
Spindles
Castor Wheels
Anti Scalp
Trimability
Tip Speed
Discharge
Belt Covers
Weight
Width
Optional Equipment
High Lift Blade
Height of cut spacers 1/4
Foam Filled 8" Tire
Recycler Kit
Atomic Blade
Three blades, one blade center section, and two 1 blade floating wings. Wings flex
up and down 12 degrees in a single plane perpendicular to from center section.
Adjustable front and rear, in .50 inch increments from 1 to 4 inches.
12-gauge steel, 5.25 inches deep, welded construction and reinforced with
10-gauge steel channels.
Three 25 inch long, .25 inch thick, heat treated steel blades.
PTO driven gearbox with 1.26–1 spiral bevel gears. One "B" section belt on center
section. One "B" section belt on each wing. Center section tensioned through
spring loaded idler. Wings tensioned through adjustable fixed idler.
Cast iron housing, 1-1/4 inch dia shaft with welded blade retainer. Turning on two
greaseable tapered roller bearings. A positive splined connection attaches pulley to
spindle shaft.
Front: Four 8 inch pneumatic wheels with greaseable roller bearings. Rear: Two 8
inch pneumatic wheels with greaseable roller bearings (one on each wing). Center
section suspended from push arms.
Anti-scalp cup (11 inch diameter) located on each blade. One anti-scalp roller on
rear of center section. Adjustable skid on right wing.
34, uncut circle, 25, uncut circle with use of individual wheel brakes.
15,000 ft./min. @ 3200 engine RPM.
Left-hand, side discharge (recycler kit available).
Steel covers bolted down, meets CE requirements.
550 lb.
83-1/2 in.
Part No. 23-2410
Part No. 54-8810
Part No. 93-5974
Model No. 30838
Part No. 106–4354
6
Advertisement
Table of Contents
