Table of Contents
Advertisement
Adjust Skid
Skid, on right side of cutting unit, should be located in
upper holes for 1 and 1-1/2 inch heights-of-cut and lower
holes for 2 to 4 inch heights-of-cut.
1. Adjust skid by removing flange nuts, positioning as
desired and re-installing flange nuts.
1
Figure 23
1. Skid
Adjust Rollers
The front anti-scalp rollers and the rear anti-scalp rollers,
located on the center deck, should be located in upper holes
for 1 and 1-1/2 inch heights-of-cut and lower holes for 2 to
5 inch heights-of-cut. Six rollers are located on the deck,
two under the main deck and two on each wing.
1. Adjust anti-scalp rollers by removing screw securing
roller shaft to deck, positioning roller as desired, and
reinstalling shaft with screw, washers, and nut (Fig. 24).
2. The two outside wing deck rollers can be adjusted at the
roller, or the bracket can be repositioned on the deck.
1
1. Roller
15
Figure 24
Advertisement
Table of Contents
