Adjust Counter Balance Spring; Grease Cutting Unit; Install Rear Weight - Toro 30799 Operator's Manual

Adjust Counter Balance Spring

1. Tighten nuts on adjusting rod until there is equal weight
on castor wheels of left and left center chambers.
1
2
Figure 15
1. Counterbalance spring 2. Adjusting rod

Grease Cutting Unit

Before the cutting unit is operated, it must be greased to
ensure proper lubricating characteristics: refer to
Lubrication, page 13. Failure to properly grease the cutting
unit will result in premature failure of critical parts.

Install Rear Weight

GROUNDSMASTER 300 Series Traction Units comply
with ANSI B71.4–1999 Standard when equipped with rear
weight. Refer to chart in Traction Unit Operator's Manual
to determine combinations of weight required. Order parts
from your local Authorized Toro Distributor.
12