Filter In The Water Inlet Hose - Bosch WVTi 2840 Instruction Manual And Installation Instructions

Replace the service flap
and close firmly
Filter in the water
inlet hose
40
Downloaded From WashingMachine-Manual.com Manuals
q Unscrew pump cover D in an anti clockwise
direction. More water will flow out.
q Remove detergent residues, foreign bodies and
lint from the inside, and clean the interior. The
pump impeller must be able to turn freely.
q Remove detergent residues, foreign bodies and
lint from the pump cover thread and pump
housing.
q Replace the pump cover and screw firmly in place.
Proceed as follows, depending on the model:
Built in appliance:
q First replace the lower part of the service flap.
Using a coin, turn plastic cover a
anti clockwise.
i The slots in the covers must be horizontal.
Stand alone appliance:
q First replace the lower part of the service flap and
then press it in place against the housing until it is
heard to click into place.
If no water or insufficient water is running into the
washer dryer:
First, reduce the water pressure in the inlet hose:
q Turn off the tap.
q Switch off the washer dryer.
q Remove the plug from the socket.
q Remove the hose from the tap.
q Clean the filter with a small brush or paint brush.
q Connect the hose.
q Open the water tap.
q Check whether water is leaking out of the end of
the hose connected to the tap.
If water is still discharged, check that the strainer is
attached properly.
1
/ turn
4