Cleaning The Water Inlet Filter - Bosch WAX32FHXGC User Manual

Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
Cleaning and servicing en
17.8 Cleaning the water inlet
filter
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
Turn off the tap.
1.
Set a programme, except for
2.
Rinse/Freshen Up, Spin or Drain.
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 11 sections
to ensure that you use the appliance
safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
61